Potential of Thuja occidentalis L. Essential Oil and Water Extracts against Field Crop Pests.

Thuja occidentalis L. essential oil (EOTO) and its compounds, such as terpinyl acetate, bornyl acetate, and ß-thujone, are claimed to be highly effective against some storage pests, sanitary insects, or pests of fruit trees, while data about its use in protecting field crops are very scarce. There is also a lack of information in the literature about the insecticidal value of water extracts from T. occidentalis (WETOs). Both essential oils (EOs) and water extracts (WEs) from various plants have advantages and disadvantages in terms of their use as insecticides. EOs are generally more effective, but their preparation is more complicated and quite expensive. In turn, WEs are simple to prepare and cheap, but they often have limited effectiveness. Moreover, significant differences in responses exist depending on the species of the donor plant, the method of preparing the extract, its concentration, the species of the pest being controlled, the developmental stage, and even the gender of the pest. The goals of the research were to assess the effect of EOTO and WETOs prepared from dry and fresh matter on the mortality, feeding, and body mass changes of important crop pests, i.e., the black bean aphid, pea leaf weevil, and Colorado potato beetle (CPB), respectively, as well as on the mortality and voracity of non-target organism Asian lady beetle young larvae. EOTO showed significant aphicidal activity with LC50 = 0.8267% and 0.2453% after 42 h of the experiment for nymphs and wingless females of black bean aphid, respectively. Adults of CPB were more resistant to EOTO than aphids, with LC50 values for females equal to 1.5327% and 1.3113% after 48 h and after 72 h of the experiment. There was no significant effect of EOTO on CPB foraging. Calculated LC50 values for pea leaf weevil adults were lower than those for CPB (0.9638% and 0.8573% for males after 12 h and 24 h, respectively). In the case of this pest, a clear reduction in foraging was obtained, with higher concentrations of EOTO resulting in more pronounced reductions in foraging behavior. Concentrations of EOTO above 0.5%, which showed efficacy against the aphid, were lethal to 3-day-old larvae of the Asian lady beetle. WETOs, in turn, showed significant potential in inhibiting adult pea leaf weevil feeding, with very low or no effectiveness in reducing A. fabae and CPB, respectively.

Contact and Gastric Effect of Peppermint Oil on Selected Pests and Aphid Predator Harmonia axyridis Pallas.

Peppermint essential oil (EO) has been extensively tested to date in reducing stored-product insects and insects of public health concern with very promising results, while only a few studies target important crop pests. There is also very little information on the effects of peppermint EO on non-target organisms, especially concerning contact and gastric effects at the same time. The goal of the investigation was the determination of the effect of peppermint EO on the mortality of Aphis fabae Scop.; the feeding intensity and weight gain of Leptinotarsa decemlineata Say. larvae; and the mortality and voracity of non-target organism Harmonia axyridis Pallas larvae. Our research indicates promising use for the M. piperita EO against aphids and young larvae (second instars) of the Colorado potato beetle. M. piperita EO showed good insecticidal efficacy against A. fabae with LC50 = 0.5442% for nymphs and 0.3768% for wingless females after 6 h. Over time, the LC50 value decreased. For the second instar larvae of L. decemlineata, the LC50 values were 0.6278%, 0.3449%, and 0.2020% after 1, 2, and 3 days of the experiment, respectively. On the other hand, older larvae (fourth instar) were characterized by significant resistance to the tested oil concentrations with LC50 value = 0.7289% after 96 h. M. piperita oil (contact and gastric effects) at a concentration of 0.5% was found to be toxic to young larvae (2 and 5 days old) of H. axyridis, while EO at a concentration of 1% was toxic to 8-day-old larvae. Thus, for the sake of ladybug safety, it would be advisable to use EO from M. piperita against aphids at concentrations lower than 0.5%.

Influence of COD in Toxic Industrial Wastewater from a Chemical Concern on Nitrification Efficiency.

COD is an arbitrary indicator of the content of organic and inorganic compounds in wastewater. The aim of this research was to determine the effect of COD of industrial wastewater on the nitrification process. This research covered wastewater from acrylonitrile and styrene-butadiene rubbers, emulsifiers, polyvinyl acetate, styrene, solvents (butyl acetate, ethyl acetate) and owipian® (self-extinguishing polystyrene intended for expansion) production. The volume of the analyzed wastewater reflected the active sludge load in the real biological treatment system. This research was carried out by the method of short-term tests. The nitrification process was inhibited to the greatest extent by wastewater from the production of acrylonitrile (approx. 51%) and styrene-butadiene (approx. 60%) rubbers. In these wastewaters, nitrification inhibition occurred due to the high COD load and the presence of inhibitors. Four-fold dilution of the samples resulted in a two-fold reduction in the inhibition of nitrification. On the other hand, in the wastewater from the production of emulsifiers and polyvinyl acetate, a two-fold reduction in COD (to the values of 226.4 mgO2·dm-3 and 329.8 mgO2·dm-3, respectively) resulted in a significant decrease in nitrification inhibition. Wastewater from the production of styrene, solvents (butyl acetate, ethyl acetate) and owipian® inhibited nitrification under the influence of strong inhibitors. Lowering the COD value of these wastewaters did not significantly reduce the inhibition of nitrification.

Assessment of the Impact of Selected Industrial Wastewater on the Nitrification Process in Short-Term Tests.

Many chemical compounds can inhibit the nitrification process, especially organic compounds used in the chemical industry. This results in a decrease in the nitrification intensity or even a complete termination of this process. As the technological design of the selected municipal and industrial wastewater treatment plant (WWTP) assumed the dephosphation process, without taking into account nitrification, it was necessary to reduce the concentration of ammonium nitrogen in the treated sewage supplied to the Vistula River. Therefore, the aim of the research was to determine the inhibition of nitrification in the activated sludge method under the influence of industrial wastewater from the production of various organic compounds and to select the most toxic wastewater in relation to nitrifiers. The assessment of nitrification inhibition was carried out on the basis of the method of short-term (4-h) impact of the tested sewage on nitrifying bacteria in the activated sludge. The research covered nine different types of chemical sewage, including wastewater from the production of synthetic rubbers, styrene plastics, adhesives, solvents and emulsifiers. The nitrification process was inhibited to the highest degree by wastewater from the production of styrene-butadiene rubbers (72%). Only wastewater from the production of methacrylate (polymethyl methacrylate) had the lowest degree of inhibition: 16%. These wastewaters also have a toxic effect on the entire biocenosis and adversely affect the structure of activated sludge flocs. The attempts to filter toxic wastewater through the ash basins significantly relieved the inhibition of nitrification.